Preliminary steps, Connecting the machine, Operating machine and controller – SINGER 1021 User Manual
Page 13: To stop the machine from sewing, A^arningl
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
preliminary steps
CONNECTING THE MACHINE
Before plugging in your machine, be sure
that the voltage and number of cycles
indicated on the plate under the hand
wheel conform to your electrical power
supply.
Push the machine plug into the receptacle
at the right end of the machine bed. Then
connect the power-line plug to your
efectrical outlet.
OPERATING MACHINE AND
CONTROLLER
To turn on both machine and sewing
light,
press power and light swith to ON
position. To turn off machine and light,
press switch at „0” to OFF position.
Power and Light
\A^ARNINGl
Turn off the po
wer and light switch before changing
needles, presser feet, and needle plates
and when leaving the machine unatten
ded. This eliminates the possibility of
starting the machine by accidentally pus
hing the speed controller.
To start the machine,
press the speed
controller. The harder you press, the fas
ter the machine will sew.
To stop the machine from sewing,
remove pressure from speed controller.
Speed Controller