L x j – SINGER 1021 User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ì i
/ 1
\ ^
Adjusting Stitch Width
L X J
Buttonhole Sewing
Butto
1
Sewing
Decorative
Stitching
at Narrow
Most used Widths
Setting for
Single Needle
Work
Adjusting Stitch Placement
Before moving stitch width and needle
position selectors make sure needle is
above fabric.
ADJUSTING WIDTH OF DESIGN
To produce a zig-zag stitch pattern, move
the stitch width selector from straight
stitch setting i to any zig-zag setting to
the right. Stitch width is increased as the
selector is moved to the right.
ADJUSTING STITCH
PLACEMENT
Most of your basic zig-zag stitching will
be done in center (
) needle position.
Left (
) and right ( J ) settings are
used for special stitch placement, as in
buttonhole sewing and button sewing.
Too Tight
Correct
Adjusting Needle-Thread Tension
ADJUSTING NEEDLE-THREAD
TENSION
Zig-zag stitching requires less needle-
thread tension than straight stitching.
Make a test sample with the fabric and
thread you plan to use so that you can
adjust the tension properly. The stitches
should lie flat against the fabric without
causing the fabric to pucker.
If the stitches are not flat and the fabric is
puckered, reduce needle-thread tension
by turning the dial to a lower number.
22