SINGER 1021 - Manual (Page 49)

removing bobbin case, face plate
and buib
DANGER:
Before removing
bobbin case, face piate and iight buib
disconnect power-iine puig from eiectri-
cal supply.
REMOVING AND REPLACING
BOBBIN CASE
• Raise the presser foot.
• Turn hand wheel toward you until
needle is above the presser foot.
• Remove needle plate as instructed on
pa§dl.
® Remove bobbin.
To remove bobbin case, turn bobbin case
holder to back as far as it will go. Lift out
bobbin case.
To replace bobbin case, guide the forked
end under the feed and then draw the
bobbin case under the position plate as
illustrated. Turn holder all the way forward
to lock bobbin case in position. After
locking bobbin case in position, check
that bobbin case is not jammed, but has
slight rotational movement.
® Replace needle plate.
• Fully close slide plate.
REMOVING FACE PLATE
• Loosen and remove screw and remove
face plate by sliding it downward.
REPLACMG FACE PLATE
® Slide face plate up so that rim is en­
gaged under edge cf top cover.
® Align screw hole at lower edge of plate
with screw hole in machine and replace
and tighten screw.
45