SINGER 1021 User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
STITCH WIDTH
Two stitch width settings are required for making buttonholes: one for side
stitching and one for the bar tack. Two possible combinations are illustrated.
Selector Setting
for Bar Tack
Selector Setting
for Side Stitching
Procedure
Set stitch length in 0-1 area of stitch
length dial. Attach special purpose foot.
Set the pattern selector at | , needle
position selector at and stitch width
selector at the width desired for the side
stitching. Place work under needle, align
ing center marking of buttonhole with
center slot in the special purpose foot.
Side Stitching
Position needle In fabric at point A.
Lower foot and stitch to end of marking.
Leave needle in fabric at point B. Raise
foot and pivot work on needle. Lower
foot. Take one stitch without changing
width setting, bringing work to point C.
Bar Tack
Adjust stitch width selector for bar tacks
and take at least six stitches. Stop at point
D.
29