M buttonhole – SINGER W612 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
21
(
6
)
Move buttonhole control os for to the right os possible. It will then latch into
position for bar tacking. Sew four or five stitches, Step 2.
(7)
Push buttonhole control down slightly and manually move to position between
Numbers 1 and 3, being sure it is against the Stop.
This will set the machine to sew in reverse.
Sew right hand side of buttonhole.
(8) Move buttonhole control as far to the right as possible, it will then latch into
position for bar tack. Sew four or five stitches. Step 4.
(9) Set buttonhole control at 0 position, extreme left, and take two or three stitches to
fasten bar tack to prevent ravelling.
no) Cut the buttonhole opening with seam ripper, being careful not to cut the stitching.
------- ----------------------------- ——
you plan to make buttonholes on
sheer
or
soft
material,
place
tarlatan
or
paper
under
fabric
which
can
be
torn
away after stitching.
When making additional buttonholes,
be sure to turn the buttonhole control
knob to 0 and back to the number 1
position to put the machine in torward
stitching.
0 1 3
2 4
1 IJgg]
m BUTTONHOLE