U f 2 – SINGER 101-12 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Press down on the bobbin and the bobbin winder
latch (A, Fig. 17) will drop down and hold the bobbin
19
U f 2
F
ig
. 17. W
inding
the
B
obbin
winder pulley against the hub of the balance wheel.
Then press the knee lever the same as for sewing.
The end of the thread must be held by the hand
until a few coils are wound and should then be
broken off. When sufficient thread has been wound
upon the bobbin, the bobbin winder is automatically
released from the balance wheel.
If the pressure of the bobbin winder pulley against
the hub of the balance wheel is insufficient for wind
ing the bobbin, loosen the adjusting screw (F, Fig. 17)
and press down on the bobbin winder until the pulley
is in contact with the hub of the balance wheel,
then tighten the adjusting screw (F).
Bobbins can also be wound while the machine is
sewing.