Singer – SINGER 101-12 User Manual
Page 35
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3. The two lower sets of bevel gears (N and O,
Fig. 33) are exposed by removing the two round
33
F
ig
. 33. B
ase
V
iew
, S
howing
B
evel
G
ears
IN B
ed
of
M
achine
sheet metal covers located in the bottom of the
machine. This can be done with a small screw driver,
4.
SINGER
M
otor
L
ubricant
should be applied
to the teeth of these two sets of gears in the same
manner as described in the upper bevel gears in 3
(g) under the heading ^^To Lubricate the Motor.’’
5. Replace the sheet metal covers.
To Oil the Controller
Also occasionally lubricate the bearing points of
the controller mechanism located beneath the ma
chine at the right of the cabinet.