SINGER 101-12 - Manual (Page 53)

To Use thé Darning Foot for
Embroidery or Darning
Put on the feed cover plate No. 66628 (A, Fig. 49).
Turn the balance wheel over toward you until the
take-up lever is at its highest point. Remove the
51
F
ig
. 49. M
achine
T
hreaded for
E
mbroidery and
D
arning
presser foot (F. Fig. 15, page 17), and attach the darn­
ing foot No. 121094 to the presser bar by means of
the presser foot thumb screw as shown above. Lower
the presser bar and move the darning foot up or
down on the presser bar until there is just room for
the material to move freely between the bottom
of the foot and the feed cover plate, then tighten
the thumb screw. Thread the machine in the usual
way, passing the thread down through the hole (B)
in the darning foot.
Having placed the work to be darned or embroid­
ered on a
SINGER
Darner or in two embroidery
hoops, raise the presser bar and place the work under
the needle as shown in Fig. 50, then lower the presser
bar. Holding the needle thread in the usual way
with the finger and thumb of the left hand, turn
the balance wheel over toward you with the right
hand to draw up the bobbin thread.