SINGER 101-12 - Manual (Page 31)

bin case bearing, as indicated by arrows in Fig. 28,
then replace the bobbin and slide plate.
To oil movable parts in the head of the machine,
take out the screw (B, Fig. 27) near the lower end of
the face plate and loosen the screw (A, Fig. 27)
29
Fig. 29. E
nd
V
iew
, S
howing
O
iling
P
oints
near the upper end of the face plate, then raise the
P late and slip it off over the head of the screw (A).
'ut one drop of oil into each of the holes and joints
thus uncovered, as shown in Fig. 29.
The gears of the motor should occasionally be
lubricated with grease from the tube of
SINGER
M
otor
L
ubricant
which is furnished with the
machine. Unscrew the spool pin (E, Fig. 27)—a slot
being cut at the top of the spool pin to permit the use
of a screwdriver. After removing the spool pin and
felt washer (D, Fig. 27) insert the tip of the motor
lubricant tube into the spool pin hole and force a
small quantity of the lubricant through the hole to
lubricate the gears, then replace the spool pin and
felt washer.
Under no circumstances should oil
be used at this hole, but only the lubricant.