SINGER W4910 Euroflair - Manual (Page 13)

Lowering the feed dog
You lower the feed dog by pushing in the upper part of
the push-button. In order to raise the feed dog again push
in the lower part.
The feed dog should be lowered for a certain type of
darning and when sewing on buttons. It is also easier to
get thick garments under the presser foot if the teeth of
the feed dog are not above the level of the stitch plate.
Removing the bobbin case
Open the door in front of the shuttle by means of the
small recess on the left side.
Grip the bobbin case with the thumb and index finger
so that the latch is depressed and pull the bobbin case
out. The bobbin will remain in the case as long as the
latch IS depressed. When you release the latch, the bob-
bin will be released.
Bobbin winding
Turn the empty bobbin until the small round mark on
one side is outward.
Slide the bobbin onto the bobbin winding spindle
located on the right side of the machine.
Raise the presser foot and pull the thread from the
thread guide by the needle clamp through the groove on
the thread guide at the right of the machine. Wind the
thread around the bobbin a couple of times, beginning
from underneath. If you are using a metal presser foot,
allow the thread to go through the eye of the needle and
under the presser foot. Never run the thread direct from
the eye of the needle to the bobbin because you will run
the risk of bending the needle. Hold the thread end and
lightly depress the foot control. As soon as winding starts
you can release the thread end.
The machine will automatically stop when the bobbin
is full. Remove the bobbin.
_LQ^^ring the feed dog, bobbin winding
11