SINGER W4910 Euroflair User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Changing the needle and presser foot
Changing the needle
Even if the needles look alike there can be slight
variations which can affect the sewing result. Be sure to
use high quality needles.
Only a completely undamaged needle will give perfect
sewing results. Therefore, change the needle if you have
the slightest reason to believe that it is bent or that the
point is damaged. To remove the needle, loosen the
screw in the needle clamp. With the flat side of the shank
away from you, insert the new needle into the needle
socket as far as it will go. Tighten the screw with the
screwdriver.
Changing the presser foot
If you wish to change the presser foot, check that the
needle is at its upper position. Remove the presser foot
by drawing it toward you while pressing slighly down
ward.
Insert the new presser foot in such a way that the
round, horizontal pin fits in between the spring and the
presser foot ankle. Press slightly downward and back
ward and the foot will snap into place.
15