Cleaning the feed dogs and shuttle area, Cleaning the outer surface of the machine – SINGER 214 User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To ensure the best possible operation of your machine, it is necessary
to keep the essential parts clean at ali times.
Always disconnect the machine from power supply by removing the
plug from the socket-outlet.
Cleaning the feed dogs and shuttle area
Cleaning the outer surface of the machine
1. Remove the lint from
the thread guides with
the lint brush as in
dicated by the arrows,
2.
Clean the outer surface
with a cloth. Dampen
the cloth with a mild
soap
if
n e c e s s a r y .
Never use thinner or
benzine.
23
1, Raise the needle to its highest position.
2, a. Remove the bobbin case from the shuttle,
b. Push aside the two shuttle keepers,
c. Remove the shuttle race cover and shuttle.
3, Clean the feed dogs and shuttle area with the lint brush.
NOTE: Put 3 drop of sewing machine oil on the center pin of the
shuttle and shuttle race as indicated by the arrows,
4, a. Be sure the shuttle race forms a half moon on the left side of the
machine,
b. Holding the shuttle by its center pin,
replace
it so as to form a
half moon on the
right
side.
c. Slide the shuttle race cover back into position,
d. Snap the shuttle keepers back into position.