Adjusting bobbin winder – SINGER W1407 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ADJUSTING BOBBIN WINDER
Correct
Incorrect
Incorrect
The thread must be wound onto the bobbin
evenly.
If the thread piles up at the bottom, loosen
the fixing screw of the winder tension and
set the tension a little higher.
hof-thi
.ff-mure...thT^arf'irwoorvd-on-at'-the-top
bobbin, push the winder tension down a
little.
After adjustment, do not forget to tighten
the fixing screw!
To locate fixing screw, open face plate. This
screw is directly under bobbin winder thread
guide inside the top cover.
Set the winder stop so that the bobbin is
filled to about % with thread. The bobbin
must stop turning when the required amount
of thread is wound. If the amount of
thread is not correct, loosen the screw and
move the winder stop as shown in the
illustration at the right.
LESS MORE
12