Zoom R16 - Manual (Page 31)

A-B repeat
30
#$࡝ࡇ࡯࠻⸳ቯㇱಽ
ߊࠅ㄰ߒౣ↢
Repeat playback of a specific section (A-B repeat)
You can set and repeat playback between a beginning point (A) and an ending point (B) in a project.
HINT
• When playback reaches point B, it automatically
goes back to point A and continues playback.
• While the A↔B icon is on, playback repeats
continuously.
• You can make these settings both during playback
and when stopped.
• If you set point B at a time before point A, repeat
playback will start from point B.
• If you want to make new settings, cancel the
previous ones by pressing the [A-B REPEAT] key
again and then make the new ones.
Setting A-B points
A-B repeat: playback repeatedly
A↔ blinks.
Press [A-B REPEAT] .
2
Press [PLAY] to start repeat
playback.
5
Press [STOP] to stop playback.
6
A-B Repeat section
Playback
1
Locate the
beginning point.
3
Locate the end point.
Press [A-B REPEAT] .
4
A↔B icon
Cancel A-B repeat and the points
Press [A-B REPEAT] again
to cancel.
7
A↔B icon off
Plays again and again