Zoom R16 - Manual (Page 7)

Basic recor
ding guide
6
Adjust the input
sensitivity, monitoring
level and output
STEP 4
3 Adjust the monitoring level.
Y o u c a n a d j u s t t h e
m o n i t o r i n g l e v e l o f a n
instrument with the fader
of the track it is being
recorded on. (INPUT 1, for
example, would be TRACK
1 or 9).
Adjust the recording level.
2
The red (0 dB) indicator
of the level meter should
not light when you apply
a n i n s e r t e ff e c t t o a n
INPUT. You should adjust
the PATCH LEVEL, for
example, if necessary.
Adjust the INPUT sensitivity with
the [GAIN] knob.
You should adjust the
[GAIN] of each INPUT so
that the PEAK indicator
blinks occasionally.
1
Ref: Recording methods in detail
: How to use the INSERT EFFECT
P.17—
P.49
NOTE
If the input signals distort during recording, adjust the
input sensitivity or recording level, referring to
Step 4.
After recording has completed, the “wait” bar will
be displayed. Do not turn the power off or take
the SD card out until the “wait” bar disappears. If
you do not follow this procedure, you may dam-
age the data or cause other problems.
Record—Complete—Play STEP 5
Start recording.
2
Press [REC] & [PLAY]
at the same time.
Press [STOP].
Stop recording.
4
Start performing.
3
P R J 0 0 3 P R J 0 0 3
0 0 0 0 : 0 0 : 1 0 : 1 5 2
The counter starts to run.
Move to the beginning.
1
P R J 0 0 3 P R J 0 0 3
0 0 0 0 : 0 0 : 0 0 : 0 0 0
Press [STOP] & [REW]
at the same time.
Record
1 Exit record standby mode.
Press the STATUS KEY to turn the green light on.
When the light changes from red to green,
the track status changes from “record
standby” to “playback standby.”
When lit green, you
can play the track.
Press the [PLAY/
MUTE/REC] key one
or two times.
3
P R J 0 0 3 P R J 0 0 3
0 0 0 0 : 0 0 : 1 0 : 1 5 2
Start playback.
Press the [PLAY] key.
Press the [STOP] key.
Stop playback. 4
Playback
2
P R J 0 0 3 P R J 0 0 3
0 0 0 0 : 0 0 : 0 0 : 0 0 0
Return to the top.
Press [STOP] & [REW]
at the same time.