Zoom R16 - Manual (Page 42)

Using a mastering eff
ect
41
Using a mastering effect
Use a mastering algorithm as an insert effect on the master track that affects just the mix down.
HINT
• When you choose a MASTERING algorithm, you
can use the MASTERING EFFECT processing on
the stereo mix.
NOTE
• If the INSERT EFFECT is applied to the [MASTER]
fader, you cannot also use the INSERT EFFECT
on track inputs.
• At step 7, if you notice any distortion of the signals
because of the MASTERING EFFECT, check
the sound of playback on the track and adjust
it by lowering all the faders. (If a track sound is
distorted, adjust that track.)
• You can select STEREO, DUAL, MIC or MASTER
algorithms. If you set another algorithm, the insert
position changes to the inputs.
Insert an INSERT EFFECT before
the [MASTER] fader.
8
Press [EXIT].
P R J 0 0 1 < M A S T E R >
0 0 0 0 0 : 0 0 : 0 0 0
Press[ ].
3
Recording signal flow to the master track
7
Audition the patches while
listening to the tracks playback,
and then select one.
Select the patch.
Change patch
M A S T E R I N G < M A S T E R >
N o . 0 3 : D i s c o M s t
Mix down/Bounce
1
Press [INSERT EFFECT].
Effect ON/OFF switch
press [ENTER].
If “INSERT EFFECT Off” is displayed,
5
Select
I n p u t S o u r c e
I N P U T 1
Change input
I n p u t S o u r c e
M A S T E R
Press [ENTER].
N o . 0 0 : P l u s A l f a
> E D I T Change menus
Change algorithms
C L E A N < I N 1 >
N o . 0 0 : S t a n d a r d
2
Select
M A S T E R I N G < I N 1 / 2 >
N o . 0 0 : P l u s A l f a
Change menus
Press [ENTER].
4
Select
N o . 0 0 : P l u s A l f a
> I N P U T S O U R C E
M A S T E R I N G < M A S T E R >
N o . 0 0 : P l u s A l f a
Press[ ].
6
N o . 0 0 : P l u s A l f a
> E D I T Change menus
.
.
MASTER.
MASTERING
>INPUT SOURCE