Bryant evolution thermostat - Manual (Page 35)

ADVANCED SETUP 31
Heating Humidity
If you have a whole house humidifier, heat recovery ventilator (HRV)
or energy recovery ventilator (ERV) as a part of your system, you can
select your desired heating humidity setting and change how your
system controls the humidifier or fresh air ventilation.
1 Open the door of the Evolution
®
Control.
2 Press the ADVANCED setup button.
3 Press the RIGHT button twice to view the HEATING HUMIDITY
screen (3 of 7).
4 Use the Right Up/Down button to select your desired humidity
setting.
5 To exit, press ADVANCED or simply close the door.
- OR -
6 If you want to change how your system controls the heating
humidity, scroll to HUMIDITY. You will have three options to
choose from:
a. OFF – The system will disable humidification or
ventilator dehumidification.
b. MANUAL – The system will control the relative humidity
in your home based on your desired set point.
c. AUTO – The system will control the relative humidity
in your home based on the setting you have selected
and outside air temperature. The humidity target is
lowered automatically as the outdoor temperature
decreases.
7 Use the Right Up/Down button to make your selection.
8 If you want to change how your system controls fresh air
ventilation, scroll to FRESH AIR. For a description of settings
see FRESH AIR VENTILATION, page 28 in this manual.
9 Use the Right Up/Down button to select AUTO, HIGH, LOW OR
DEHUM.
10 To exit, press ADVANCED or simply close the door.