3)scanning[14 – Yaesu FT-60R User Manual
Page 14
R. G. Sparber KG7MQL
February 22, 2015
Page 14 of 52
3)Scanning[14]
You must be in VFO mode to scan a range of frequencies (see page 11). If you
are in Memory mode, you will scan a set of stored frequencies [37].
The scanning will begin at the current
VFO frequency. If you push the
Up key for about 1 second, the frequency
will increment until it detects an active
frequency or reaches the top of the band
(see page 11). Then it will wrap around
to the lowest frequency in that band.
Similarly, if you press the Down key, the
frequency will decrement until it reaches
and active frequency or the bottom of the
band and then wrap around to the top.
If you press the up (or down) keys for less than 1 second, the displayed frequency
will increase (or decrease) by the step size [77]. If you press the up or down keys
for more than 1 second, scanning begins as if you let up on the key after 1
second.