Yaesu FT-60R - Manual (Page 29)

R. G. Sparber KG7MQL February 22, 2015 Page 29 of 52
Memory Mode: Labeling Memories [30]
The sequence works but I will add a few comments that might make it clearer.
Along with the generic steps necessary to label a memory, I will use Chanel
Memory 000 to illustrate the steps.
Step 2: briefly press the
F W key, and then hold down
the 0 key until the display changes.
This new display will have
a number in the upper left corner and
some text.
Step 3: When you rotate the Dial knob, the
number and text should change. Stop when
you get to 28, NaMe WRiTe. There does not
seem to be a time limit for how long you stay
in the SET mode.
Step 4: It says to "press the
F W key momentarily to display the
previously stored label (if any)". Even if you
do not want to see the previously stored label,
you must execute this step.
In Step 1, I selected Chanel Memory 000.
Here you see the previous name assigned to
this address.