Yaesu FT-60R - Manual (Page 26)

R. G. Sparber KG7MQL February 22, 2015 Page 26 of 52
Memory Mode: Memory Recall [29]
If you do not see a number in the upper left
corner, then you are in VFO mode. Briefly press
the V/M key and a number should appear.
If you see a number in the upper left corner, then
you are in Memory mode and can proceed.
Note that
BANK is displayed below the number.
This means that within Memory mode you are
within one of the 10 Memory Banks. You are
limited to scrolling through the channels stored in
the selected BANK. See page 37 for how to select
a Memory Bank.
If you do not see BANK displayed below the
number, then you are in Memory mode but "NO
BANK" has been selected. This state lets you scroll
through all Channels which is handy if you can't
remember the channel numbers. See page 37 for how to select NO BANK.
Regardless of what Bank you are in, you can recall channels 1 through 999 by
entering the Channel number and then pressing
F W. To recall channel 000 you
must enter 1000.
If you look back to the figure on [27], you will notice a dashed line joining the
Standard Memory Channels to the PMS Memory Channels. The reason for this
line becomes evident as you recall PMS Memory Channels. The last paragraph of
Memory Mode: Memory Recall [29] explains the details. I can't say that it is all
that user friendly.
Memory Recall VFO- VM/Dial
Memory Recall: MEM- Dial
Memory Recall: MEM- keypad numbers/FW