Scanning [35, Scanning: vfo scanning [35 – Yaesu FT-60R User Manual
Page 40
Advertising
R. G. Sparber KG7MQL
February 22, 2015
Page 40 of 52
Scanning [35]
The Operating Manual says that when the scanning function stops when an active
channel is found and you are then able to talk to the station if desired. This
depends on frequency. The Specifications [79] show the wide range of receive
frequencies and the relatively narrow range of transmit frequencies.
Scanning: VFO Scanning [35]
Manual VFO Scan
When an active channel is detected, scanning will pause
or stop depending on the Scan-Resume technique [35]
defined. This state is indicated by
flashing the decimal point.
You can cancel scanning by briefly pressing the PTT key. This does
not cause the radio to transmit.
Advertising