Ctcss/dcs operation: ctcss operation [22 – Yaesu FT-60R User Manual
Page 21
R. G. Sparber KG7MQL
February 22, 2015
Page 21 of 52
Repeater Operation: Manual Repeater Shift
Activation [20]
Manual Repeater Shift Activation: Checking the
Repeater Uplink (Input) Frequency [21]
See page 19.
CTCSS/DCS Operation: CTCSS Operation [22]
Use the Dial knob.
I was confused by the paragraph labeling of this section until I made the
following changes:
• Step 2: put "a" after the 2
• Step 3: cross out 3 and put "b" in its place
• Step 3-1 ("You may notice a REV TN") cross out "1)" and put "c" in its
place
• Step "2)" ("You may notice a DCS") cross out "2)" and put in "d" in its
place
• Step 4: cross out 4 and make it 3
• Step 5: cross out 5 and make it 4
• Step 6: cross out 6 and make it 5
• Step 7 [23]: cross out 7 and make it 6
With this new labeling, it is clearer to me that rotating the Dial knob brings up
various options.
I once ran into a repeater that supposedly required a CTCSS tone that was not in
the table. I know of no way to set such a tone on the FT-60.
CTCSS Operation: FW/1/DIAL to TONE/PTT/FW/2/DIAL to PL/FW