Yaesu FT-60R - Manual (Page 34)

R. G. Sparber KG7MQL February 22, 2015 Page 34 of 52
Memory Mode: Deleting Memories [32]
We are talking about
deleting entries in the
Channel memory here and
not about deleting pointers to this channel
memory from within Memory Banks. That topic
will be covered on page 38.
Refer to page 23 for more detail on Channel Memory versus Memory Banks.
When the contents of a given Channel has been
deleted, you will be unable to see that Channel
number until you store a new frequency in that location.
The above also applies to the Upper and Lower register sets.
Deleting Memories: FW 1s/DIAL/HMRV briefly
Memory Mode: Moving Memory Data to the VFO [32]
This function moves a frequency stored in a Channel Memory into the Variable
Frequency Oscillator register. Once in the VFO register, it acts the same as if you
entered the frequency via the keypad. It also sets the offset, PL, and power to the
values stored in this Channel Memory location.
When you follow the sequence correctly, the display will show VFO-IN for
about 2 seconds.
Channel 000 145.000 MHz
Channel 001 145.500 MHz
Channel 002 435.000 MHz
Channel 003 435.500 MHz
Channel 004 145.800 MHz
Channel 001 (blank)