Cisco 15327 - Manual (Page 46)

2-2
Ethernet Card Software Feature and Configuration Guide, R7.2
Chapter 2 CTC Operations
Displaying ML-Series Ethernet Ports Provisioning Information on CTC
Displaying ML-Series Ethernet Ports Provisioning Information
on CTC
The Ethernet port provisioning window displays the provisioning status of the Ethernet ports. Click the
Provisioning > Ether Ports tabs to display this window. For ML-Series cards, only the Port Name field
can be provisioned from CTC. The user must configure ML-Series ports using the Cisco IOS CLI.
Auto in a column indicates the port is set to autonegotiate capabilities with the attached link partner.
All ML-Series cards do not display all columns. Table 2-2 details the information displayed under the
Provisioning > Ether Ports tab:
Table 2-1 ML-Series POS and Ethernet Statistics Fields and Buttons
Button Description
Refresh Manually refreshes the statistics.
Baseline Resets the software counters (in that particular CTC client only) temporarily to zero
without affecting the actual statistics on the card. From that point on, only counters
displaying the change from the temporary baseline are displayed by this CTC client.
These new baselined counters are shown only as long as the user displays the
Performance window. If the user navigates to another CTC window and comes back
to the Performance window, the true actual statistics retained by the card are shown.
Auto-Refresh Sets a time interval for the automatic refresh of statistics.
Table 2-2 CTC Display of Ethernet Port Provisioning Status
Column Description ML1000-2 ML100T-12 ML100X-8
Port The fixed number identifier for the
specific port. 0 or 1 0-11 0-7
Port Name Configurable 12-character
alphanumeric identifier for the port. User specific User specific User
specific
Admin State Configured port state, which is
administratively active or inactive.
UP and DOWN UP and
DOWN
UP and
DOWN
Link State Status between signaling points at port
and attached device. UP and DOWN UP and
DOWN
UP and
DOWN
MTU (Maximum Transmission Unit) Largest
acceptable packet size configured for
that port. Default value is
1500 Default value
is 1500 Default
value is
1500
Speed Ethernet port transmission speed. — Auto,
10Mbps, or
100Mbps 100Mbps
Duplex Setting of the duplex mode for the port. — Auto, Full, or
Half Full