Using the setup program – Dell 7500 User Manual

Page 117

Advertising
background image

support.dell.com

Using the Setup Program

B-1

A P P E N D I X B

Using the Setup Program

This appendix describes the Setup program, which you can use to configure your
computer system as well as enable and disable your system’s password features.

Your computer retains system configuration information in the nonvolatile
random-access memory (NVRAM) maintained by your computer’s reserve battery.
Each time you turn on your computer, the system compares the installed hardware
with the system configuration information stored in NVRAM. If the system detects
a discrepancy, it generates an error message that identifies the incorrect configuration
setting.

You can use the Setup program as follows:

To change your system configuration information after you add, change, or
remove hardware connected to or installed inside your computer

To verify information about your computer’s current configuration, such as the
amount of system memory

To set or change user-selectable features — for example, power management or
security features

NOTE: Many of the options that are configured in the Setup program are
overridden by the settings in the Windows control panels, such as the Power
Management
control panel. When your computer is running the Windows 98
operating system, it will use the settings that are selected in the Windows
control panels rather than those set in the Setup program.

Advertising