Dell 7500 - Manual (Page 34)

2-4 Dell Inspiron 7500 System Reference and Troubleshooting Guide
To change a device in the MegaBay, perform the following steps:
1. Save and close any open files, and exit any open application programs.
2. Turn off the computer.
3. Remove the currently installed device from the MegaBay:
a. Close the display and turn the computer over so that it is oriented as
illustrated in Figure 2-3.
b. Push the latch lock to the unlocked position, and slide the latch release in the
direction of the arrow shown in Figure 2-3. Keep holding the latch release
with one hand while pulling the device out of the MegaBay with the other.
Figure 2-3. Removing a Device From the MegaBay
4. With the latch lock unlocked, slide the new device into the MegaBay until you
hear it click into place.
The label on the device will be facing away from you when you have the
computer turned over as shown in Figure 2-3.
5. Press the latch lock to the locked position to secure the device in the MegaBay.
The new device is available when you turn the system on again.
battery
latch
MegaBay
device
latch lock
(unlocked
position)
bottom of computer