Dell 7500 - Manual (Page 40)

2-10 Dell Inspiron 7500 System Reference and Troubleshooting Guide
3. Remove any installed batteries from the MegaBay and/or media bay. For
instructions, refer to “Using the MegaBay” and/or “Using the Media Bay”
found earlier in this chapter.
4. Ground yourself by touching a metal input/output (I/O) connector on the back of
the computer.
5. Turn the computer over, and remove the memory module cover as shown in
Figure 2-8.
Slide the memory module cover as far as it will go in the direction of the arrow,
and then lift it away from the computer.
Figure 2-8. Removing the Memory Module Cover
NOTICE: To prevent damage to the computer, do not use tools to spread
the inner metal tabs of the socket when you are installing or removing
a memory module.
6. If you are replacing one or more memory modules, remove the memory
module(s) as shown in Figure 2-9.
NOTE: If one memory module is already installed and you are adding a second
memory module, put the second module in the available slot. Removing existing
module(s) is necessary only if they are being replaced. Depending on how you
ordered your computer, one or two modules may already be installed.
Using your fingernails, carefully spread apart the inner metal tabs of the memory
module socket just far enough for the memory module to disengage from the
socket (the module should pop up slightly). Then lift the memory module away
from the socket.
bottom of computer
memory module
cover