Ditch Witch JT1220 - Manual (Page 118)

JT1220 Mach 1 Operator’s Manual
Systems and Equipment - 117
Anchor System
CMW
Anchor System
Drive Anchors
1. Use anchor rotation and thrust controls to
drive anchor into ground.
2. Anchor is set when cap (1) rests firmly on
centering tube (2).
3. Repeat process for other anchor.
Remove Anchors
1. Use anchor rotation and thrust controls to
slowly remove anchor shaft from ground.
2. Repeat process for other anchor.
Crushing weight. If load falls or moves, it could kill or crush
you. Use proper procedures and equipment or stay away.
NOTICE:
• Drive anchors properly before drilling.
• Stand on platform when operating anchor controls.
• Wear high-top protective boots with legs of pants completely tucked inside.
• Wear protective gloves.
• If you are not driving two anchors to full depth, drive optional ground rod into soil away from drilling
unit and connect ground rod to drilling unit.
Turning shaft can kill you or crush arm or leg. Stay away.
NOTICE: Do not replace anchor collar bolt with one longer than original. Clothing could
catch on turning shaft.
IMPORTANT: Carefully time anchor rotation
with anchor movement. Properly driven
anchors should not auger up soil.