EXFO AXS-200/850 Ethernet Test Set - Manual (Page 75)

RFC 2544
Ethernet Test Set 65
Stream Configuration
³
If DS is selected, go to the next field to
enter the hexadecimal code 00 to FF or
go to the field underneath to enter the
binary code.
The possible values are shown as follows:
³
Flow Label (For IPv6 only): Enter the Flow Label value. The
acceptable range is from 0 to 1048575. The default value is 0.
³
Source/ Dist. UDP Ports: Enter the Source UDP Port. The accepted
range is from 0 to 65535. The default value is 49184. Destination UDP
Port: Enter the Destination UDP Port. The accepted range is from 0 to
65535. The default value is 7.
Parameter Value
DSCP Codepoints 000000 (CS0), 001000 (CS1), 010000 (CS2),
011000 (CS3), 100000 (CS4), 101000 (CS5),
110000 (CS6), 111000 (CS7), 001010 (AF11),
001100 (AF12), 001110 (AF13), 010010 (AF21),
10100 (AF22), 010110 (AF23), 011010 (AF31),
011100 (AF32), 011110 (AF33), 100010 (AF41),
100100 (AF42), 100110 (AF43), 101110 (EF)
Default: 000000 (CS0)
ECN 00 (Not-ECT), 01 (ECT-1), 10 (ECT 0),11 (CE)
Default: 00 (Not-ECT)