EXFO IQS-1500 Power Meters for IQS-500/600 - Manual (Page 153)

SCPI Command Reference
Power Meters 145
Product-Specific Commands—Description
:SENSe[1..n]:POWer:WAVelength
Description This command selects a new operating
wavelength on the specified channel. If no
channel was specified, the default value used is
1.
Syntax :SENSe[1..n]:POWer:WAVelength<wsp><Wave
length>|MAXimum|MINimum|DEFault
Parameter(s) Wavelength:
The program data syntax for <Wavelength> is
defined as a <numeric_value> element. The
<Wavelength> special forms MINimum,
MAXimum and DEFault are accepted on input.
MINimum allows to set the instrument to the
smallest supported value.
MAXimum allows to set the instrument to the
greatest supported value.
DEFault allows the instrument to select a value
for the <Wavelength> parameter.
The <wavelength> parameter is an operating
wavelength using meter as units. Any
wavelength within the spectral range of the
instrument optical detector at 1 nm resolution
(0.1 nm for the IQS-1500). See the power meter
instruction manual for the exact spectral range
for each detector type.