EXFO IQS-1500 Power Meters for IQS-500/600 - Manual (Page 82)

Calibrating Other Power Meters with the IQS-1500
74 IQS-1100/IQS-1500
Storing Reference Power Meter Measurements Automatically
To enter auto-store details and start the associated calculations:
1. Select the wavelength at which you want to perform the calibration
using the arrow buttons on each side of the Select Wavelength box.
2. Select the source you want to use for your calibration using the arrow
buttons on each side of the Select Source box.
3. Type in the delay (in seconds) you want the power meter to wait
between measurements.
4. Type in the number of measurements to be performed in the (M) box.
5. Click Start to start the calculations.
If this result is not satisfactory, you can start over by clicking Erase this
result. You must then restart the calculation with Start.
Once you are satisfied with your results, proceed to the next step by
clicking Next.