Datalogic Scanning Connection Box C-BOX 150 - Manual (Page 16)

C-BOX 150
2
After system functioning has been verified, close the C-BOX 150 using the 4 cover
screws making sure the rubber seal is fitted correctly between the parts of the
housing.
NOTE
It is recommended to use the dedicated grounding cable (included in
the package) to improve the C-BOX 150 noise immunity.
Simply connect its open end to the scanner cable’s fixing screw and
the other end to the ground, as shown in the figure below.
2.4.1 Power Supply
Power is supplied to the C-BOX 150 through the pins provided on the spring clamp
connector.
The power switch (see Figure 6) switches the power supply ON or OFF for both the
C-BOX 150 and the connected scanner.
ON
OFF
Figure 6 - Power Switch ON/OFF Positions
8