Datalogic Scanning Connection Box C-BOX 150 - Manual (Page 8)

GUIDE TO INSTALLATION
The following can be used as a checklist to verify all of the steps necessary for
complete installation of the C-BOX 150.
1) Read all information in the section "Safety Precautions" at the beginning of this
manual.
2) Correctly position and mount the C-BOX 150 within the reach of the barcode
scanner cable, according to the information in paragraph 2.3.
3) Make all electrical connections according to your application. See par. 2.4 and
2.6.
Further typical layouts are given in the Scanner Reference Manual.
4) Set all the proper configuration jumpers and switches according to your
application.
See all sub-paragraphs under 2.4.
5) Connect the scanner to the C-BOX 150.
6) Switch-on the system.
7) Wait until the Warning Led (WL, red) is switched off.
8) Through the internal 9-pin male connector, (it carries the Scanner Aux. Serial Port
signals), configure the scanner according to your specific application using either
the Genius™ or WinHost™ software configuration tool, see par. 1.2 for program
compatibility.
9) Force the 'Get Scanner Configuration' procedure using the internal keys (see
paragraph 2.5.1).
10) Wait until the Warning Led (WL, red) is switched Off.
Now the C-BOX 150 contains the scanner configuration.
The installation is complete.
viii