Datalogic Scanning Connection Box C-BOX 150 - Manual (Page 19)

INSTALLATION
2
The C-BOX 150 spring clamp connector pinouts are indicated in the following table.
Refer to the scanner Reference Manual for details.
Scanner Pinouts
Pin Name
1, 3, 5 VS
2, 4, 6 GND
7, 8 EARTH GROUND
*9, 13 RS485 CABLE SHIELD
20, 40 RESERVED
35 TX AUX
37 RX AUX
DS1100
DS2200 DS2100A
DS2400A DS2100N
DS2400N DS4600A DS6X00 DX6400
DS8100A
DX8200A
21 OUT1+ OUT1+ OUT1+ OUT1+ OUT1+
22 IO REF OUT REF OUT1- OUT1- OUT1-
23 OUT2+ OUT2+ OUT2+ OUT2+ OUT2+
24 IO REF OUT REF OUT2- OUT2- OUT2-
25 NC NC NC RESERVED OUT 3A
26 IN1- NC NC RESERVED OUT 3B
27 EXT TRIG+ EXT TRIG+ EXT TRIG A EXT TRIG+ EXT TRIG/PS A
28 EXT TRIG- EXT TRIG- EXT TRIG B EXT TRIG- EXT TRIG/PS B
29 NC NC NC IN1+ IN 2/ENC A
30 IO REF NC IN2- IN1- IN 2/ENC B
31 NC NC NC IN2+ IN 3A
32 NC NC NC IN2- IN 4A
33 RESERVED RESERVED RESERVED RESERVED IN 3A
34 RESERVED RESERVED RESERVED RESERVED IN 4A
36 NC RTSA ID-NET- GND IN 3B/IN 4B
38 NC CTSA ID-NET+ SGND AUX GND
39 SGND SGND GND SGND GND
DS2100A/N DS2400A/N DS4600A DS6X00 DX6400 DS8100A DX8200A
RS232 RS485FD RS485HD 20mA CL
(with INT-30 only)
*11, 15 TX232 TX485+ RTX485+
*12, 16 RTS232 TX485- RTX485-
17 RX232 RX485+
18 CTS232 RX485-
*10, 14, 19
SGND MAIN SGND MAIN SGND MAIN
See INT-30
instructions
DS1100 DS2200
RS485HD
*11, 15 RTX485+
*12, 16 RTX485-
17 RESERVED
18 RESERVED
*10, 14, 19 SGND MAIN
* The signals on pins 9, 10, 11 and 12 are repeated on pins 13, 14, 15 and 16 to facilitate network
connections (i.e. Multiplexer connections using the RS485 half-duplex Interface). In this way the network bus
can enter and exit the C-Box 150 from different spring clamps but be physically connected together.
11