Labconco FilterMatPortable Exhausters 3970024 User Manual
Page 9
5
Product Service 1-800-522-7658
C
C
H
H
A
A
P
P
T
T
E
E
R
R
2
2
P
P
R
R
E
E
R
R
E
E
Q
Q
U
U
I
I
S
S
I
I
T
T
E
E
S
S
Before you install your FilterMate and XPert or XVS Enclosure,
you need to prepare your site for installation. Carefully examine
the location where you intend to install your FilterMate and
enclosure. You must be certain that the area is reasonably level
and of solid construction. An electrical source must be located
near the installation site.
Carefully read this chapter to learn:
• the electrical supply requirements.
• the exhaust requirements.
• the location and preparation requirement.
Refer to Appendix B: FilterMate Specifications for complete
FilterMate electrical, dimensions, environmental conditions,
specifications and requirements.
Electrical Requirements
Both the 115V and 230V FilterMate require 10 amp circuits. The
motor/blower uses 2A and the switched auxiliary outlet has a
maximum capacity of 8A. 230V model is shipped without a plug
and the customer must install the appropriate plug used in their
installation. If an airflow monitor is used with the enclosure, it is
recommended that the airflow monitor be connected directly to the
FilterMate’s auxiliary outlet so the airflow monitor is powered at
the same time. If this is not possible, the airflow monitor may be
connected to the auxiliary outlet on the accessory fluorescent light.