Labconco Protector Stainless Steel Radioisotope Laboratory Fume Hoods 9682200 - Manual (Page 41)

37
Product Service 1-800-522-7658
Chapter 6: Maintaining Your Protector Radioisotope Fume
Routine Service Operations
Front Panel Removal:
1. Simply lift the front panel up and then away from
the hood to provide access to the top.
Changing the Fluorescent Lamp:
1. Turn light switch to “OFF.”
2. Remove the front panel as noted earlier.
3. Reach over the front header of the hood and remove
the knock out plugs at both ends of fixture. Lift
fixture up.
4. Remove the fluorescent lamp by pushing it out of
the spring-loaded lamp socket and swinging it out
of the other lamp socket.
5. Install the new lamp by reversing the removal
procedure.
Your Next Step
After you understand the maintenance procedures, you
are ready to proceed to Chapter 7: Modifying Your
Protector Radioisotope Fume Hood.
S A