Luxul XBR-2300 - Manual (Page 20)

20
XBR-2300
a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450
LUX-UG-XBR-2300 Vers: 07314
„
IP Group: This mode allows for the control of bandwidth provided to groups of
client devices. When using this mode, specific IP address ranges are placed in groups
and assigned to a particular port (WAN1 or WAN2). The source address, destina-
tion address, and destination port are all specified. All data packets included in the
defined range are then processed by the selected WAN interface. All data packets
that are not included in the defined range are forwarded to the other WAN interface.
Example: To designate that LAN Source IP addresses with a range of 192.168.0.100 to
192.168.0.200 pass through WAN1 and with a Destination IP Address range of 58.251.80.1
to 58.251.80.254, via ports: 0-65535, you need to fill in the corresponding source IP
Addresses, Destination IP Addresses, Destination Ports, and Designate a WAN port.
To activate this setting, check “Enabled” and click “Add to the corresponding list.” See
below for details:
NOTE: All packets which are not included in the configured range
will be handled by WAN2.
NOTE: If rules are configured more than once or have overlapping
parameters, only the most recently configured rules will be valid.
5.3.4 DHCP Server
Settings include IP Address, Subnet Mask, Gateway and DNS Server. With DHCP Server, IP
addresses are assigned automatically by the XBR-2300. Simply enable the DHCP Server
to automatically configure the IP Address of all new devices on the LAN.
DHCP Server: Select this option if you want DHCP to automatically assign and
configure device IP Addresses.
„
Starting IP Address: The first IP Address allowed to be assigned by the
DHCP Server.
„
Ending IP Address: The last IP Address allowed to be assigned by the
DHCP Server.