Luxul XBR-2300 - Manual (Page 41)

41
User Guide
© 2014 Luxul. All Rights Reserved.
Other trademarks and registered trademarks are the property of their respective owners
„
ID: Displays the device UPnP ID (usually the ID of the network card)
„
Remote Host: Description of the remote device that receives or sends data
„
External Port: The external port number used for forwarding UPnP traffic
„
Internal Host: Description of the internal device receiving or sending data
„
Internal Port: The internal port number used for forwarding UPnP traffic
„
Protocol: Displays the protocol TCP/UDP of the UPnP traffic
„
Description: Displays the configured message of the UPnP device serving traffic
5.6.3 One-to-One NAT
Requires the IP Address of a local device to NAT behind the specified public
WAN IP Address.
„
LAN Starting Address: Enter the desired LAN IP Address
„
WAN Starting Address: Enter the WAN IP Address you wish to NAT behind
„
IP Count: Enter the number of IP Addresses immediately after the LAN Starting
Address you wish to perform a One-to-One NAT
„
Enable: Enables the configured One-to-One NAT rule
Example: If you enter 192.168.0.10 in the LAN starting IP address, 172.138.112.111 in the WAN
starting IP address and 5 in the IP Count field, this means that that devices with LAN IPs
192.168.0.10—192.168.0.14 and WAN IPs: 172.138.112.111—172.138.112.115 are to use a One-to-
One NAT relationship.