Luxul XBR-2300 - Manual (Page 50)

50
XBR-2300
a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450
LUX-UG-XBR-2300 Vers: 07314
6 REGULATORY COMPLIANCE
This device is approved under the Luxul brand and designed to comply for use specifically with other
approved Luxul devices. This device is designed to be compliant with rules and regulations in locations
where they are sold and will be labeled as required. Any changes or modifications to Luxul equipment,
not expressly approved by Luxul, could void the user’s authority to operate the equipment. This Luxul
device when used in conjunction with the approved Luxul Models should be professionally installed and
the Radio Frequency Output Power will not exceed the maximum allowable limit for those countries that
have regulatory approval.
Health and Safety Recommendations
Warnings for the use of Wireless Devices: Please observe all warning notices with regard to the
usage of wireless devices
Potentially Hazardous Atmospheres: You are reminded of the need to observe restrictions on the
use of radio devices in fuel depots, chemical plants etc. and areas where the air contains chemicals or
particles (such as grain, dust, or metal powders).
Safety in Hospitals: Wireless devices transmit radio frequency energy and may affect medical electrical
equipment. When installed adjacent to other equipment, it is advised to verify that the adjacent equip-
ment is not adversely affected.
Power Supply: Use only a Luxul approved power supply output rated at 100-240VDC and minimum 0.1A.
The power supply shall be Listed to UL/CSA 60950-1; and certified to IEC60950-1 and EN60950-1 with
SELV outputs. The device can also be powered from a compliant POE source. Use of alternative power
supply will invalidate any approval given to this device and may be dangerous.
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
„ Reorient or relocate the receiving antenna
„ Increase the separation between the equipment and receiver
„ Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected
„ Consult the dealer or an experienced radio/TV technician for help.