Delta Electronics AC Motor Drive VFD-G User Manual
Delta Electronics Tools
Advertising
Table of contents
Document Outline
- Preface
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Wiring
- Chapter 3 Keypad and Start Up
- Chapter 4 Parameters
- 4.1 Summary of Parameter Settings
- Group 0 User Parameters
- Group 1 Basic Parameters
- Group 2 Operation Method Parameters
- Group 3 Output Function Parameters
- Group 4 Input Function Parameters
- Group 5 Multi-step Speed Parameters
- Group 6 Protection Function Parameters
- Group 7 AC Drive and Motor Parameters
- Group 8 Special Parameters
- Group 9 Communication Parameters
- Group 10 PID Control Parameters
- 4.2 Parameter Settings for Applications
- 4.3 Description of Parameter Settings
- Group 0: User Parameters
- Group 1: Basic Parameters
- Group 2: Operation Method Parameters
- Group 3: Output Function Parameters
- Group 4: Input Function Parameters
- Group 5: Multi-step Speed Parameters
- Group 6: Protection Function Parameters
- Group 7: AC Drive and Motor Parameters
- Group 8: Special Parameters
- Group 9: Communication Parameters
- Group 10: PID Control Parameters
- 4.1 Summary of Parameter Settings
- Chapter 5 Troubleshooting
- 5.1 Over Current (OC)
- 5.2 Ground Fault
- 5.3 Over Voltage (OV)
- 5.4 Low Voltage (Lv)
- 5.5 Over Heat (OH)
- 5.6 Overload
- 5.7 Keypad Display is Abnormal
- 5.8 Phase Loss (PHL)
- 5.9 Motor cannot Run
- 5.10 Motor Speed cannot be Changed
- 5.11 Motor Stalls during Acceleration
- 5.12 The Motor does not Run as Expected
- 5.13 Electromagnetic/Induction Noise
- 5.14 Environmental Condition
- 5.15 Affecting Other Machines
- Chapter 6 Fault Code Information and Maintenance
- Appendix A Specifications
- Appendix B Accessories
- Appendix C How to Select the Right AC Motor Drive