Vortech 1994-1995 Ford 5.0 Mustang - Manual (Page 10)

P/N: 4FG020-010
© 2008 Vortech Engineering, Inc.
All Rights Reserved. Intl. Copr. Secured
04NOV08 V2.0(94-95 5.0 Mus.(4FG V2.0))
2
SENDER
1/4” NPT x 45 o
ELBOW
1/4” NPT x -4
OIL PRESSURE
SENDER BOSS
1/4” NPT NIPPLE 1/4” NPT TEE
ENGINE
BLOCK
1/4” NPT TEE
10 O’CLOCK
POSITION
1/4” x
45 o ELBOW
SENDER
SENDER
1/4” NPT x 45 o
ELBOW
1/4” NPT x -4
OIL PRESSURE
SENDER BOSS
1/4” NPT NIPPLE 1/4” NPT TEE
ENGINE
BLOCK
1/4” NPT TEE
10 O’CLOCK
POSITION
1/4” x
45 o ELBOW
SENDER
A. Remove the oil filter for access to the oil pres-
sure sender. Remove the oil pressure sender
and install the tee fitting so that it points up
and forward, towards the radiator at the 10
o' clock position.
B. Install 45° elbow into the end of the tee fitting
positioned as shown in the graphic. Reinstall the
oil pressure sending unit and wiring.
C. Thread the oil feed line onto the TEE and route
towards the engine oil fill port.
D. Fit a 24" length of the 1/2" flex loom onto the oil
line for abrasion protection.
NOTE: Cover the end of the fitting with a plastic bag
to keep debris from entering the system.
WARNING: DO NOT use any sealant or sealing
tape on oil feed lines. Use ONLY engine
oil on oil line threads or damage to the
supercharger is possible and the warranty
will be void!
Fig. 2-a / Front View
Fig. 2-b / Driver's Side View
2. OIL FEED LINE (ENGINE OIL-FED KITS ONLY. APPLICATIONS WITH V-3 SUPER-
CHARGERS SKIP AHEAD TO STEP 4)