Vortech 1994-1995 Ford 5.0 Mustang - Manual (Page 18)

P/N: 4FG020-010
© 2008 Vortech Engineering, Inc.
All Rights Reserved. Intl. Copr. Secured
04NOV08 V2.0(94-95 5.0 Mus.(4FG V2.0))
10
F. Slide the 3-1/8" x 1" sleeve onto the stock mass
air sensor. Slide the flex hose and #52 hose clamp
over the assembly.
G. Mount the hose and mass air assembly onto the
mounting bracket using the four 1/4-20 bolts,
washers and nylock nuts.
h. Screw the air temperature sensor into the bracket
and plug in the electrical connector for the MAF
and the air temp sensor.
I. Slide the air filter and clamp assembly onto the
bracket and secure.
INLET DUCT
A. Slide the inlet duct along with the T-type clamp
onto the supercharger inlet. (See Fig. 13-a.)
B.* Place the oil drain hose onto the supercharger drain
fitting and secure with a hose clamp. Arrange the
clamp screw housing so it will not interfere with
the mounting plate when installed.
C.* Feed the oil drain hose around the side of the
smog pump and down towards the oil pan fitting
while lowering the supercharger into position.
D. Secure the supercharger with four (4) 3/8-16 x 1"
bolts and AN washers.
E.* Connect the lower end of the oil drain hose to the
fitting on the pan and secure with a hose clamp.
Drain must be routed downhill with no kinks or
dips. Trim hose if necessary.
F. Place the supercharger belt idler assembly on the
supercharger using the 12mm bolts and washers.
Position the thin head bolt in the tensioner plate
nearest the idler pulley.
G. Attach the 3-1/2" elbow assembly and 3-1/2 x 2"
sleeve to the supercharger inlet duct using the
#56 clamps. Route the flex hose end through the
opening in the fender apron and attach to the
MAF sensor outlet. Secure hose to MAF with the
supplied #52 clamp.
h.**Secure the remote drain hose away from the belt
and other hoses using tie-wraps.
13. SUPERCHARGER MOUNTING AND ASSEMBLY, HOSE DRAIN AND INLET DUCT
Fig. 13-a
12. MASS AIR FLOW SENSOR RELOCATION cont'd.
* Applies to "engine oil-fed" units only. V-3 applications
skip these steps.
** Applies to V-3 applications only