Vortech 1994-1995 Ford 5.0 Mustang - Manual (Page 16)

P/N: 4FG020-010
© 2008 Vortech Engineering, Inc.
All Rights Reserved. Intl. Copr. Secured
04NOV08 V2.0(94-95 5.0 Mus.(4FG V2.0))
8
A. Remove the crankshaft pulley.
B. Place the Vortech crank pulley onto the crank
balancer and secure with the four supplied grade
8 bolts and washers.
C. Install the Vortech water pump pulley using stock
fasteners.
A. Sandwich the smog pump between the casting and
front supercharger mounting plate using the five 3/8-
16 x 1" bolts and AN washers. On the upper smog
pump bolt hole use the 3/8-16 x 5" bolt, 3/8" nut and
AN washer with .189 spacer behind the front plate
and the 3/8-16 x 1-1/4" bolt and AN washer on the
lower mount of the smog pump.
B. Install the assembled bracket onto the engine using
one 7/16-14 x 2-1/4" bolt and two 3/8-16 x 2-1/4"
and one 3/8-16 x 1-1/2" bolt and AN washer.
C. Connect the smog pump diverter inlet hose to the
smog pump discharge.
D. Mount the triangular shaped alternator bracket using
two 5/16-18 x 1" bolts and AN washers as shown.
E. Using the factory mounting
bolt, mount the accessory belt
tensioner onto the Vortech main
bracket.
ALTERNATOR BRACKET 3/8-16 x 4"
(THROUGH
ALTERNATOR)
5/16-18 x 1"
7/16-14 x 2-1/4"
MOUNTING
BRACKET
3/8-16 x 2-1/4"
3/8-16 x 1-1/2"
3/8-16 x 1-1/4"
3/8-16 x 1"
3/8-16 x 1"
3/8-16 x 1"
3/8-16 x 5"
AND NUT
.189" SPACER
(BEHIND PLATE)
MOUNTING PLATE
NOTE: Tighten bolts progressively and evenly in a
crisscross pattern so that pulleys align properly.
10. MAIN BRACKET AND SUPERCHARGER MOUNTING PLATE
Fig. 10-a
9. CRANKSHAFT AND WATER PUMP PULLEYS