Vortech 1994-1995 Ford 5.0 Mustang User Manual
Page 19
P/N: 4FG020-010
© 2008 Vortech Engineering, Inc.
All Rights Reserved. Intl. Copr. Secured
04NOV08 V2.0(94-95 5.0 Mus.(4FG V2.0))
11
ALTERNATOR
IDLER
POWER
STEERING
WATER
PUMP
A/C
SMOG
PUMP
CRANK
NOTE: SPACERS ARE
LOCATED BEHIND
ALTERNATOR STAY
5/16"SPACER
SUPERCHARGER
MOUNTING PLATE
SUPERCHARGER
MOUNTING BOSS
A. Mount the alternator to the alternator bracket
and main bracket using a 3/8-16 x 4" bolt and
washer. Reconnect the two wiring plugs and
battery lug to the alternator.
B.* Thread the oil feed line onto the supercharger
fitting.
C. Route the coolant hose over the oil fitting/hose
assembly.
D. Mount the alternator stay to the supercharger
and supercharger mounting plate using two
3/8-16 x 1-1/2" bolts and washers, 5/8" spacer
and 5/16" spacer. Place the 5/8" spacer in be-
tween the upper supercharger mounting bolt
hole and the alternator stay. Place the 5/16"
spacer in between the upper supercharger
mounting plate hole and the alternator stay
(see Fig. 14-b). Bolt the alternator to the upper
alternator stay slot using the 3/8-16 x 1-3/4"
bolt, washer, lock washer and nut.
E. Install the main accessory belt using a 3/8"
breaker bar to rotate the tensioner clockwise,
allowing the belt to fit over all of the pulleys.
(See Fig. 14-a.)
F. Mount the supercharger belt on the crank pul-
ley and supercharger pulley with the tensioner
routed according to the graphic. Tighten the
belt using a 1/2" breaker bar, a 3/4" tappet or
a 19mm thin wrench to tighten the bolts.
14. ALTERNATOR AND MAIN ACCESSORY BELT INSTALLATION
Fig. 14-a
Fig. 14-b
* Applies to "engine oil-fed" units only. V-3 applica-
tions skip these steps.