Vortech 1994-1995 Ford 5.0 Mustang - Manual (Page 20)

P/N: 4FG020-010
© 2008 Vortech Engineering, Inc.
All Rights Reserved. Intl. Copr. Secured
04NOV08 V2.0(94-95 5.0 Mus.(4FG V2.0))
12
15. DISCHARGE DUCT INSTALLATION
A. Fit the 3" x 2" sleeve onto the throttle body and
secure with the supplied #48 clamp. Loosely slide
the remaining clamp onto the sleeve.
B. Slide the 2-3/4" x 2" sleeve and clamps onto the
discharge tube assembly.
C. Fit the discharge tube onto the throttle body tube
and slide the 2-3/4" x 2" sleeve onto the super-
charger discharge port, tighten down the #44
clamps on both sides.
D. Using the 3/8" hose mender and length of 3/8"
hose supplied, fit into the stock PCV hose and
route to the barb fitting on the inlet duct of the
supercharger. (See Fig. 15-a.)
DISCHARGE
TUBE
3-1/2" x 1" HOSE
VACUUM HOSE
2-1/2" x 1" HOSE
INLET
DUCT
A. Slide the 1" x 3-1/2" hose onto the bypass
valve. Secure with #16 hose clamps. (See
Fig. 16-b.)
B. Slide the 1" x 2-1/2" hose onto the discharge
duct and bypass valve. Secure with hose
clamps. Trim hose length if necessary.
C. Route the 5/32" vacuum line to the bypass
valve and FMU TEE as shown (See Fig. 16-
a.)
D. Using the supplied TEE and length of hose,
cut the hose 4" from the FMU.
E. Install the tee fitting and connect the hose to
the bypass valve.
TO
VACUUM
TEE
HIGH OUTPUT
KIT ONLY
TO BYPASS
VALVE
20"
4"
NOTE: In some instances you may have to trim or shorten
these ducts for fit and ease of installation due to
differences in components.
Fig. 15-a
16. BYPASS VALVE INSTALLATION (High-Output System Kit Only)
Fig. 16-b Fig. 16-a
OIL
STOCK
PVC
HOSE
3/8” HOSE
MENDER
3/8” HOSE
TO INLET DUCT