Lenco BTT-2 - Manual (Page 15)

15
Connecting the device to a power supply
The operations in this chapter should not be performed by children.
Before connecting the device to the mains, make sure that the mains voltage
corresponds to the voltage that is suitable for the device. The information
about a suitable mains voltage can be found in the specification table. If you
are unsure about the mains voltage at your current location, please contact
the utility company.
Make sure the outlet to which the device is connected is easily accessible.
Before connecting the device, please make sure that the main power switch
on the back of the device is in the OFF position. If you cannot find the switch,
please check the section Exploring the device (number 17) to see where this
switch can be found.
Do not touch the metal parts of the power cable, because there is a risk of
shocks with personal injury.
Stopping the device in an emergency
In “fail situations” it might be needed to have the device make an emergency
stop. For instance when smoke or a strange smell is coming out of the
device, when the device is making a strange noise, etc. You can stop the
device in emergencies by:
Disconnecting the power cord from the outlet.
Always pull the plug of the power cord, never the
cord itself.
If the outlet is not accessible, go to the meter
cupboard and switch off the corresponding group or
the ground fault circuit breaker.
When a fail situation has occurred, make sure to
contact your dealer or the Lenco helpdesk before using the device again. Explain to
the employee what happened, the employee will then advise you whether it’s wise to
start using the device again.