Lenco BTT-2 - Manual (Page 31)

31
Troubleshooting
Problem Solution
No power.
Check if the plug is inserted firmly into the
outlet.
Put the main switch on the back of the
device in the on position.
Make sure the power outlet is powered.
To save energy, during playback, if not any
operation in about 4 hours, the unit will
switch to standby mode automatically.
No sound or poor sound.
Adjust the volume or disable the mute
function.
Check the input source.
The device does not respond or responds
poorly. Remove the plug from the outlet for at least
5 minutes.
Settings or selections are suddenly
cancelled.
There is a time limit for settings and
selections. Repeat the steps.
Radio stations cannot be received or can
barely be heard because of hiss.
Fully extend the wire antenna.
Re-position the wire antenna.
Increase the distance between the device
and other equipment.
Bluetooth® music stutters.
Place the Bluetooth® device closer to the
radio.
The remote control does not work.
Check the input source.
Keep the remote control closer to the device.
Check the batteries and replace if needed.
Aim the remote control directly on the remote
control sensor on the front of the device.
The SD/USB media does not play.
The format of the files is not supported.
The SD card or the USB device is not
compatible with the device, try using a
different SD card or USB device.