Subaru 2005 Legacy User Manual

Page 351

Advertising
background image

6-34

Interior equipment

4. Using both hands, simultaneously push the hand-

held transmitter button and the desired HomeLink®

button. DO NOT release the buttons until step 5 has

been completed.

5. Hold down both buttons until the HomeLink® indi-

cator light flashes, first slowly then rapidly. When the

indicator light flashes rapidly, both buttons may be re-

leased. (The rapidly flashing light indicates successful

programming of the new frequency signal.)

6. Press and hold the programmed button and check

the HomeLink® indicator light.

If the indicator light stays on continuously, your garage

door should activate and the programming is complet-

ed.

If the indicator light flashes rapidly for two seconds

and then stays on continuously, your garage door

opener may be protected by a rolling code feature. In

this case you need to perform the additional steps for

“Rolling-code-protected garage opener programming

in the U.S.A.” described below.

NOTE

Rolling-code-protected garage door openers are

manufactured after 1996. See the instruction man-

ual of your garage opener for confirmation.

7. Reconnect the motor of your garage door opener to

the outlet.

8. Test your garage door opener by pressing the pro-

grammed HomeLink® button.

!

Programming rolling-code-protected

garage door openers in the U.S.A.

If your garage door opener has a rolling code feature,

program the HomeLink® Wireless Control System for

it by following steps 1 through 5 in the “Programming

garage door openers in the U.S.A.” section above and

then continuing the steps below.

NOTE

The assistance of a second person may make the

programming quicker and easier.

UB6219CA

Advertising