Desa CGD3018PT/NT - Manual (Page 17)

www.desatech.com 111160-01C 17
INSTALLATION
Continued
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
Dual Burner Biltmore Split Oak Models
CCL3018PTA/NTA, CCL3924PTA/NTA,
CCL3930PTB/NTB
Each log is marked with a number. These num-
bers will help you identify the log when install-
ing. It is very important to install these logs ex-
actly as instructed. Do not modify logs. Only use
logs supplied with heater.
1. Place the front log (#1) on the grate fingers.
Make sure the front log rests firmly between the
grate fingers and the grate base (see Figure 24).
2. Place the base of the middle log (#2) in the U-
shaped slots of the grate base. The cutout on the
right of the middle log should fit over the burner
(see Figure 25). Make sure the front of the middle
log is resting on the tabs of the grate base.
3. Locate pins on the bottom of back log (#3).
Slide these pins into the holes in the grate base
behind the burner (see Figure 26).
4. Locate holes on the bottom of crossover log
(#4). Slide front hole onto the left pin
(CCL3924PTA/NTA or CCL3930PTB/NTB)
or middle pin (CCL3018PA/NA or
CCL3018PTA/NTA) on the middle log (#2)
and the pin on the back log (#3). See Figure
27 for placement.
Figure 25 - Installing Middle Log #2
(CCL3930PTB/NTB Shown)
Figure 26 - Installing Rear Log #3
(CCL3930PTB/NTB Shown)
Middle
Log (#2)
Tab
Burner
U-Shaped Slot
Hole in
Grate Base
Pins
Burner
Rear
Log (#3)
Figure 24 - Installing Front Log #1
(CCL3930PTB/NTB Shown)
Front
Log (#1)
Grate
Fingers
Grate
Base
Figure 27 - Installing Crossover Log #4
(CCL3930PTB/NTB Shown)
Middle
Log (#2)
Back Log
(#3)
Pins
Crossover
Log (#4)