Desa CGD3018PT/NT - Manual (Page 18)

www.desatech.com 111160-01C 18
INSTALLATION
Continued
Figure 28 - Installing Crossover Log #5
(CCL3930PTB/NTB Shown)
Crossover
Log (#4)
Front Log (#1)
Crossover
Log (#5)
Crossover
Log (#4)
Front
Log (#1)
Figure 29 - Installing Crossover Log #5
and Log #6 (CCL3018PA/NA and
CCL3018PTA/NTA Only)
Crossover
Log (#5)
Middle
Log (#2)
Crossover
Log (#6)
7
6
Figure 30 - Installing Crossover Log #6
(CCL3930PTB/NTB Shown)
Figure 31 - Installing Crossover Log #7
(Model CCL3930PTB/NTB Only)
Pins
Middle
Log (#2)
Front
Log (#1)
Middle
Log (#2)
Crossover
Log (#6)
Holes
Pins
Crossover
Log (#6)
Crossover
Log (#7)
5. For CCL3924PTA/NTA and CCL3930PTB/NTB
Only:
Locate pin and hole on the bottom of
crossover log (#5). Slide the pin into the hole
located in crossover log (#4). Slide the hole onto
the pin on front log (#1). See Figure 28.
For CCL3018PA/NA and CCL3018PTA/NTA
Only:
Locate holes on the bottom of crossover
log (#5). Slide the holes over the left pins on
middle log (#2) and front log (#1). See Figure 29.
6. Locate holes on the bottom of crossover log
(#6). Slide these holes onto the right pins lo-
cated in middle log (#2) and front log (#1).
See Figure 30 for CCL3924PTA/NTA or
CCL3930PTB/NTB. See Figure 29 for
CCL3018PA/NA or CCL3018PTA/NTA.
7. For CCL3930PTB/NTB only: Locate holes on
the bottom of crossover log (#7). Slide onto
the pins located in crossover log (#6) and
middle log (#2). See Figure 31.
8. Add lava rock around base of heater if desired.
Do not place any lava rock on logs or burner.